I have tested this application, hoping to be able to store data send via Bluetooth to my Storage Card.
This application is only working when this application is explicitely executed only, not when I activate bluetooth just, isn't it ?

Compared to the built-in app, I don't see a reason to have it. From the built-in bluetooth app, you can also activate wireless stereo, which you can not with this application.

[DanneG]

The creator working on a version that runs as a service.

[bjy8138]

nice.. finally there's sthg tat can save my transfer in storage card and won't freeze when transferring

ok, Dr Yar's show the sender ID, does this one shows the ID???

Does not work on HP iPAQ 212 WM6 classic

[wam]

as I Tested it : in my opinoin the best BT receiver till now : "Dr-Yar BT 1.5.1" 4 the following reasons :
* faster than wm5 beam functn
* can recive when PPC on Stand by
* can save directly to Storage card
Dr-Yar BT 1.6 is much better BUT it has a fatal error that it may stop the transfer e'out any known reason

This Prog :: MoBlue can reach the trans rate of 32KB/s but
cause errors when in stand by = can't recive while in stand by mode
when reciving big files the progress takes longer time so ====> the PPC goes into Stand by = Stop transferring

it the owner fixed this errors it will be much better
i suggest also adding an icon when runnin in the notification or sys. tray areas

ThX

Much thanks for this feed back. My previous experience of Dr Yar was that it was a bit inconsistent. I will probably give both a try to see how they stack up (pun intended. )

working great(MIO A501)