Doesn't work on Asus p535 (WM5)

[speed200]

There is no way to make it work again... f... off Anton.

UPDATE 17/6/2007
v 2.50.199
http://www.wizcode.com/downloads

ANY SERIAL--------->

UPDATE 17/6/2007
v 2.50.199
http://www.wizcode.com/downloads

ANY SERIAL--------->

IF ANY ... PLEASE DISTRIBUTE VIA PM ONLY; SO WILL AVOID TO BE BLACK LISTED BY ANTON !!!

serial by PM, pls

Serial by PM please

[SunDevil]

PM serial please 20warez reward for new serial v2.50...

[k1ll3r]

PM serial plz!

You should probably PM people ONLY with high post counts on these forums. Anton could easily register on here and ask for the serial by PM.

please serial no. also for me

Let's just wait till the load is stable. Obviously there were a lot of serious bugs in the recent loads and I think it starts 2.4x.x

I would not trust his scandisk and safe mode from those loads to begin with.

[cencio]

You should probably PM people ONLY with high post counts on these forums. Anton could easily register on here and ask for the serial by PM.

Right observation.

Probably a great program but I'm very surprised that this release is not put off from this site because of real problems.

I installed it. It worked but when I used "safe" mode, my pda hang and I had many difficulties to restore a backup...

So, avoid this program...

Best regards

[antt]

Could also use a serial. PM me please.

Regarding PM people with high post, Anton can also register, say "thank you" or "well done" or just place comments in other topics and can thus gather high post as well.

You should probably PM people ONLY with high post counts on these forums. Anton could easily register on here and ask for the serial by PM.

Or at least see what their prior posts were, AND WHEN...I'm new here, relatively, but I think my notes in this period should certainly point the dread finger in a different direction!

However, I do think you are correct as the thought crossed my mind earlier today as well...

As regards the note above about it 'hanging' up...I've read the same thing here in previous release notes. I think SKTools is probably the superior program.